Winter use on a property looks like this: start the tractor cold, clear the laneway in fifteen minutes, park it. Or start it and let it idle for twenty minutes to warm the cab. Either way, the engine rarely gets properly warm, and a modern diesel needs that more than the old ones did.
None of this needs a service visit. It's mostly about how you run it.
Why short runs are hard on an engine
An engine that never reaches operating temperature doesn't burn off the moisture and unburnt fuel that collect in the crankcase in the cold. They mix into the oil, and the oil breaks down sooner. A cold start also takes a lot out of the battery, between the glow plugs and the starter, and a fifteen-minute run may not put it back.
If most of your winter is short runs:
- Give it a proper working session now and then. Push the snowbanks back or do some loader work, long enough for the engine to come right up to temperature under load.
- Watch the oil interval. Ask us, or check your manual, whether winter short-run use calls for changing it sooner than the normal interval.
- Keep the battery charged. A maintainer on a tractor that sits between storms is cheap insurance.
Long idling doesn't warm it up properly
A diesel at idle makes very little heat, so it warms up slowly and it can take a long time to get there. Long idling also builds up soot and can dilute the oil with fuel.
Warm it up the way your manual describes, then do light work until the temperature gauge comes up. That warms the engine and the hydraulics faster than sitting. When you're stopping for a while, shut it off rather than leaving it idling.
If your tractor has a DPF
Most current diesel tractors from about 25 to 75 horsepower have a diesel particulate filter (DPF). Above 75 horsepower, they generally have a DPF and also use diesel exhaust fluid (DEF). Your manual will confirm what yours has.
The DPF catches soot and burns it off from time to time. That burn-off is called regeneration, and it needs heat and load, which is exactly what short runs and idling don't give it.
- Know the indicator. Learn what the regeneration light on your dash looks like, and what your manual says to do when it comes on.
- Don't ignore it. If the tractor asks for a parked regeneration, do it the way the manual describes, parked clear of anything that can burn. The exhaust gets very hot.
- Use the oil your manual lists. The oil spec matters more on engines with a DPF.
If yours is over 75 horsepower and uses DEF, keep the spare jug somewhere it won't freeze, and never add anything to it.
Start it the easy way
- Plug in the block heater before a cold start. A timer makes it easy.
- Let the glow plugs finish before you crank, following the start procedure in the manual.
- Crank in short bursts, with a rest between tries, as the manual describes.
- Never use starting fluid on an engine with glow plugs or an intake heater. Manufacturers warn against it because it can damage the engine.
For winter fuel and the water separator, see the fall compact tractor service piece.
Warm-up procedures, oil specs and regeneration steps vary by engine, so let your operator's manual set them.