A blade or a pusher is about the simplest thing you can hang on a machine, and that's why it gets ignored. It sat in the long grass all summer, and the first time anyone looks at it is at four in the morning in the first storm. Most of what goes wrong is easy to find on a dry afternoon in the fall.
This applies whether it's a rear blade on a compact tractor, a front blade on a loader, or a pusher on a skid steer.
Cutting edge: replace it before it wears into the moldboard
The cutting edge is a wear part. The moldboard behind it isn't. Once the edge wears past the limit your manual gives, the moldboard starts to take the wear, and that's a much bigger repair than an edge.
Check the edge across its full width. If it's worn more on one end, the edge usually isn't the problem. The shoes or the mount aren't level, so fix that at the same time. If the edge is reversible, flip it. If it's done, replace it now, when parts are easy to get. Use new edge bolts rather than reusing rounded or stretched ones, and tighten them to the manual's spec.
Trip mechanism: make sure it trips and comes back
Most blades and many pushers are built to trip when they hit something solid: a frozen curb, a manhole lid, a rock. That protects the blade, the machine and the operator.
- Trip springs: look for cracks and check that the tension is set to the manual. Cranked tighter than spec, the blade stops tripping, and the hit goes into the frame and the machine instead.
- Pivots: grease them, and with the blade lowered and the engine off, check that the trip moves freely and returns.
- Pushers with sectioned or trip edges: make sure each section moves on its own and springs back. Check rubber edges for tears and wear.
Shoes and skids
Shoes set how the edge rides. On gravel, set them so the edge rides just above the stones, or you'll plow the laneway onto the lawn. On pavement you can run closer. Worn-out shoes let the edge dig in, so replace them when they're thin.
Pins, pivots and angling
- Check every pin and clip is there and the holes aren't worn oval. Worn holes let the blade shift and wear everything around them faster.
- On a hydraulic angle blade, look over the cylinders, hoses and fittings. Check for a leak with a piece of cardboard, never your hand.
- Grease the centre pivot and the angle cylinder ends.
The mount
Look over the mounting frame or brackets for cracked welds and loose bolts. A crack that starts in November will be a break by February. If the blade goes on a quick-attach, make sure the locking pins or wedges engage fully on both sides every time you hook it up.
See both ends of the blade
In the dark, with snow blowing, it's hard to tell where the ends of the blade are. Blade markers or guide rods on each end help a lot, especially on a wide pusher or when someone else is running it.
Wear limits, spring tension and bolt torque vary by blade, so let the operator's manual for that attachment set the specs.